Jeep WK Grand Cherokee SRT8 Racing Pedals by Lear

By Jeep Experts

Welcome to the jeepExperts.com showcase web page on the WK Generation Jeep Grand Cherokee SRT8 racing pedals by Lear. Did we miss something? Please get in contact with us and inform us about it!

Lear racing type pedals customary gear on the Grand Cherokee SRT8

Mopar p/n 05290949AC $57.60 MSRP

Pedal dimensions

Rear view of the lear pedals

Brake pedal pad set up

Note: If you aren’t snug performing this set up process, please contact your native Chrysler, Dodge or Jeep seller for help.

1. Remove the previous brake pedal pad from the pedal.

2. Lubricate the brand new pedal pad with a mix of rosewater or soapy water within the space of the bottom of the rear sides. Do not soak or submerge pad in water.

3. Slide the pad (1) on the pedal (2) from the decrease a part of the pedal upwards to the highest, then work the pad sides over the pedal. Reach the rubber high a part of the pad and pull the rubber over the pedal, all 4 sides of the rubber pad should be stretched over the metal pedal. A trim stick or screwdriver would assist in set up. Ensure that the highest of the pad os totally seated previous the pedal arm (3) and pedal.

See also  Jeep WK Grand Cherokee Engine Oil and Filter Change

NOTE: Firmly pull on the pedal pad to make it possible for the pad is not going to come off in all instructions, particularly the downward course.

WARNING: Failure to make sure that the pad is safe might consequence within the pad coming unfastened which can or may lead to unsafe brake pedal software.

4. Using a mirror (4) look behind the brake pedal (2) to make it possible for the pedal pad is totally seated (3) over the pedal. Use your finger to hint the rubber edge to verify that the pad surrounds the pedal.

Gas pedal overlay set up

Note: If you aren’t snug performing this set up process, please contact your native Chrysler, Dodge or Jeep seller for help.

1. The fuel pedal overlay has two units of tabs, locking tabs (1) and holding tabs (2).

2. Install the fuel pedal overlay pad (2) with the holding tabs locked underneath the left aspect of the fuel pedal (1), then rotate the overlay (2) towards the proper aspect of the pedal (4) whereas making use of strain to the highest and backside to seat the locking tabs (3) in place underneath the again aspect of the pedal (4).

3. Using a mirror look behind the fuel pedal (4) to make it possible for the overlay (2) is locked into place by the locking tabs (3).

NOTE: Firmly pull on the pedal overlay to make it possible for the pad is not going to come off.

WARNING: Failure to make sure that the pad is safe might consequence within the pad coming unfastened which can or may lead to unsafe fuel pedal software.

See also  Jeep WK Grand Cherokee Interior Trim & Audio Component Removal

Leave a Comment